0
Owner's of the Bissell Vacuum Cleaner 22C1 gave it a score of 0 out of 5. Here's how the scores stacked up:
11
www.bissell.com 800.237.7691
Maintenance and care
Checking rotating floor brush and drive belt
You should check your vacuum cleaner’s rotating
floor brush and drive belt regularly for wear or
damage. You should also clean the brush and brush
ends of strings, hair, and carpet fibers. These can
wrap around the brush and hamper its ability to
effectively clean your carpet. Also remove any debris
that has accumulated under the brush cover.
1. Unplug cleaner from electrical outlet.
2. Place handle in low position and turn
vacuum cleaner over so bottom side is up.
3. Remove the five screws with a Phillips head
screwdriver. Lift the brush cover off.
4. Grasp rotating floor brush at both ends and lift.
5. Clean strings, hair and other debris from
rotating floor brush, paying particular
attention to brush ends.
6. Clean strings, hair and other debris from
motor pulley and drive belt areas.
7. Check drive belt carefully for wear, cuts or
stressed areas.
8. Check air passageway for obstructions.
Remove debris from this area.
Replace drive belt
Use only genuine BISSELL style 9 replacement
belts (#32074) in your BISSELL Cleanview Helix.
1. Unplug cleaner from electrical outlet.
2. With rotating floor brush removed from
vacuum cleaner (steps 1-4 of Check rotating
floor brush and drive belt), grasp old drive
belt and remove from motor pulley. Discard
old drive belt.
3. Place new drive belt over motor pulley and
stretch other end over rotating floor brush in
the space between the bristles.
4. Place ends of rotating floor brush down into
slots on sides as shown.
5. Turn rotating floor brush by hand several
times in the direction of motor pulley. If
properly installed, drive belt will center itself
on rotating brush.
6. Reposition brush cover and screw back into
place.
Brush Cover
Motor Pulley
Air Passageway
Motor
Pulley
3.
4.
8.
Find Your Products By Category
Please Login
